Skip to main content

Archive

Show more

Reasons for Diesel Engine Cylinder Liner Wear





Diesel engine cylinder liner should keep air intake system clean in the process of using. Avoid working without installing air filter. In addition, avoid overloading operation, maintain a good cooling condition and check the diesel engine cylinder liner periodically. However, any equipment used for a long time will wear. What are the reasons for diesel generator cylinder liner wear? The main reasons are as follows:

First. Incorrect oil brand

This will result in a poor lubrication and lead to a serious wear of cylinder liner.

Second. Use inferior diesel

Severe coking after combustion, which will lead to a serious wear of cylinder liner.

Third. Filter failure

Especially air filter fracture, the air come into the cylinder without passing filter short circuit. Due to the dust in the air, impurities enter the cylinder, which is easy to lead to a serious wear of diesel engine.

Fourth. Quality and assembly problems of diesel cylinder liner.

Fifth. Operational problems

Cold-starting, especially cold-starting in winter, due to the oil viscosity and poor mobility, it will lead to insufficient oil supply provided by oil pump. Meanwhile, the oil of diesel genset on the cylinder wall flow down after parking. Thus, it won't be so lubricated as usual at the moment of starting. There is no doubt that it will increase wear of cylinder liner.


Last but not least, driving at low temperature.


It can't maintain a good lubrication due to the low temperature so as to increase wear of cylinder liner.


The above contents are the main reasons for diesel engine cylinder liner wear, which are shared by Jiangsu Starlight Electricity Equipment Co.,Ltd. Hope it is useful for all users. As a wholly-owned subsidiary of Jiangsu Starlight Power Group, we are the leading manufacturer of alternator, diesel generator, Cummins diesel generator set, and Volvo generator set. In addition, we are also one of earlier manufacturers of diesel generator and diesel genset in China. Starlight has already established 46 service outlets all over the country. We chronically offer customers technical consulting, free debugging, maintenance and training.



Comments

Popular posts from this blog

New Yuchai engine YC6K600-D30 power for diesel generator 50Hz

Technical Parameters of Boduan 500KW Weichai Generator Set 6M33D572E200

  The 6M33D633E200 diesel engine is a special-purpose diesel engine for land-based power generation in the M33 series. It is a new-structure power generation diesel engine with a centrally - located turbocharger developed by Weichai Power Co., Ltd. in 2016. Continuous Power (COP): The maximum power at which the diesel engine can run continuously under a constant load with no limit on the annual operating hours. It is the ISO standard power. Prime Power (PRP): The maximum power at which the diesel engine can run continuously under variable loads with no limit on the annual operating hours. It is an ISO standard power that allows a 10% overload. Standby Power (ESP): The maximum power in a certain variable - power series that the diesel engine can operate for up to 200 hours per year. It is an ISO standard power with limited fuel consumption.   Operating Conditions and Applications of Baudouin  500KW Weichai Generator Set  Diesel Engine Power Classification Operating Co...

How to know and solve faults of genset voltage transformer

 Today Starlight Power shares the common faults for voltage transformer of diesel generator set. Hope it is helpful to you. 1) The insulation between iron chips is damaged. Fault phenomenon: temperature rises during operation. The possible causes of the failure are: poor insulation between iron chips, bad use of environmental conditions or long-term operation under high temperature, which promote the insulation aging between iron chips. (2) Poor contact between grounding plate and iron core. Fault phenomenon: there is discharge sound between iron core and oil tank during operation. Cause of failure: the grounding plate is not inserted tightly, and the mounting screw is not tightened. (3) The iron core is loose. Fault phenomenon: abnormal vibration or noise during operation. The cause of failure: the iron core clamp is not clamped, and the iron chip is loose. (4) Turn to turn short circuit of winding. Fault phenomenon: during operation, the temperature rises, there is ...