Skip to main content

Posts

Showing posts from May 20, 2018

Archive

Show more

Checking signal Cable Rail Pressure Sensor of Volvo Engine

Checking signal Cable Rail Pressure Sensor  of Volvo Engine Tools: 885675 Break-out cable 88890074 Multimeter 1 Cut the current with the main switch. 2 Disconnect the connector from the sensor. 3 Connect break-out cable 885675 to the cable harness connector to the engine control unit. 4 Use multimeter 88890074 to do resistance measurement against the engine control unit. NOTICE! Measurement is done to eliminate short circuiting or breaks in the cable to the engine control unit. Checking injection control pressure sensor Tools: 885675 Break-out cable 88890074 Multimeter 1 Turn ignition off. 2 Disconnect the connector from the sensor. 3 Connect break-out cable 885675 between the sensor and the engine control unit. 4 Use multimeter 88890074 for voltage measurement. 5 Turn ignition on. Checking the wiring to the MPROP valve Tools: 88890074 Multimeter NOTICE! If any of the measurements shows an...

Volvo Penta TDTAD Series Engine Data

Volvo Penta TDTAD Series Engine Data Lubrication System Oil change intervals can vary between 150 and 500 hours depending on the quality of the lubricant and the sulphur content of the fuel. Note that the oil change interval should never be longer than 12 months. If longer intervals are required than those stated in the table below, the condition of the oil must be tested regularly by the oil manufacturer. 1) If sulphur content is > 1.0% by weight, use oil with TBN > 15. 2) Lowest recommended oil type, engine oil of an higher type can always be used. 3) API: CG-4 or CH-4 are acceptable in markets outside Europe, instead of ACEA E3. Viscosity Select the viscosity according to the table. The temperature values refer to stable ambient temperatures. * SAE 5W/30 refers to synthetic or semi-synthetic oils. Fuel System Fuel specification Fuel must comply with national and international standards for commercially supplied fuels. ...