Starlight generator

Today, we will briefly introduce the maintenance method of the water tank of Volvo diesel generators. If anyelse you need to know about that, welcome to visit our Starlight website, and then we will introduce the relevant information to you. Cleaning of the water radiator: The water radiator needs frequent maintenance to ensure the heat exchange between the coolant and the air. Under normal circumstances, the exterior and interior of the water radiator should be cleaned every 500 hours of   Volvo diesel generator   work. To clean the internal scale and precipitated impurities, first drain the water in the radiator, and then use clean water with a certain pressure (such as tap water) to pass into the radiator core until the water flowing out is clean. Maintenance of the water radiator: After the water radiator has been used for a period of time, if there is a leak, it can be repaired with solder. When the individual pipes are seriously damaged and cannot be repaired, the pipes are allow

Recently, Jiangsu Starlight Electricity Equipments Co.,Ltd. and Guangxi Gangqi Investment Co., Ltd. successfully signed a   500KW diesel generator set   and an environmental protection and noise reduction project for the engine room. It is understood that these two sets will be used in Fangchenggang Evergrande Yuelanwan Project.   The 500KW diesel generator set ordered by the customer adopts a well-known brand engine with high horsepower, large torque, high stability, low fuel consumption, low emission, low noise and high cost performance. This 500KW diesel generator integrates the leading technologies of large and medium-sized diesel engines from all over the world, and is equipped with booster pressure intercooling, high-pressure common rail, and motor-controlled single pump. It has the characteristics of green environmental protection, high stability, strong loading capacity, and good maintenance characteristics.   Starlight Power can provide engineering project services such as die

The oil-water separator for   diesel generator sets   uses the principle of oil-water density difference to make the oil float on the top, and the particulate matter and sludge settle at the bottom. It is regularly cleaned and eliminated by the submersible cutting pump installed in the sedimentation chamber, and there are also separation elements such as diffusion cone and filter screen inside. In order to allow the diesel generator set to use fuel safely and safely, the oil-water separator has been installed by the diesel generator set manufacturer before leaving the factory. The following are the replacement steps of the oil-water separator.   Install the oil-water separator of the diesel generator set and replace it as follows: 1. Open the water valve and let off part of the fuel.   2. Use a belt wrench to remove the filter element and the water storage cup together, and then remove the water storage cup from the filter element. Both the filter element and the water collecting cup a