Starlight generator

4.14.2 Haul ： Remember not to let the generator weight similar or exceeding the capacity of the trailer truck when moving the generator, otherwise, it will influence the flexibility and brake capability of the trailer truck. ！ Generator hauling must comply with all specifications, standards, other rules and traffic regulations, including rules of the device as well as maximum and minimum speed limits. ！ If there’s braking system, make sure it is in good condition. ！ It is allowed to ride on the diesel generator , or stand and ride on the towbar, or stand or walk between the trailer truck and generator. The inclination shall not exceed 150  (27%). Avoid hollow, rocks, barriers, and soft or weak ground. Be sure about the site-clearing behind during backing-up. 4.14.3 Park ： Stop the car on dry place where can support the weight...

Low oil pressure is one of the common faults of generator. The method of quick troubleshooting is helpful to solve the problem in time. Below Jiangsu Starlight Electricity Equipment Co.,Ltd will teach you how to accurately find the cause of generator engine oil pressure problem. 1. Check the oil pressure display device Use replacement method to check, that is to replace the oil pressure gauge or sensor. If the oil pressure display is normal after replacement, the oil pressure display device has trouble. If the oil pressure indicator is normal, the oil pressure is reduced, and the fault is in the lubricating part, the following method should be used to judge. Check oil temperature If the oil temperature is too low and the oil pressure is also low. But when the temperature rises, the oil pressure is still normal, it is due to the excessive oil and the bad oil passage. For example, the original impurity of the oil filter is affected by the original impurity and the oil...

1. Engine Operation - CCEC Cummins (1) Engine normal starting requirements a. Starting motor runs not exceeding 30s every time, and then re-starting interval is 2 min. b. The lubricating oil pressure should reach 70 KPa within 15s after starting, otherwise, the oil level should be checked immediately. c. After starting, idle speed 3-5min can only be added load, otherwise, the bearing bush will be in short of oil supply in an instant. d. Idle speed can not exceed 10 minutes, otherwise there will be combustion chamber carbon, supercharger oil leakage and other undesirable phenomena. e. Engine water temperature should not be less than 60 ℃ , otherwise, the fuel will enter the oil and destroy lubrication. f. Keep the engine at idle speed after starting in winter until the water thermometer pointer turns or 10min later, then it can be put into operation. While observing the water thermometer, and also pay attention to whether the oil pressure gauge meets the requirements...