Skip to main content

Archive

Show more

Dingbo Power Exported A 250KVA Volvo Diesel Generator to Malaysia

 Dingbo Power is an original manufacturer of diesel gensets. In August, 2023, we produced a prime power 250kva Volvo diesel generator ordered by a client from Malaysia and delivered the goods on time. Thanks for the client’s trust and support.


Basic information of the genset


Manufacturer: Guangxi Dingbo Generator Set Manufacturing Co.,Ltd.

Genset model: DB-200GF

Type: Silent type

Prime rating: 200kw/250kva

Standby rating:220kw/275kva

Rated voltage: 415/240V

Rated Current: 348A

Speed/frequency: 1500rpm/50Hz

Phase & Wire: 3 Phase 4 Wire

Power factor: 0.8lag

Diesel engine: Volvo TAD841GE

Alternator: Leroy Somer TAL-A46-D

Controller: SmartGen HGM6120CAN


Dingbo Power Exported A 250KVA Volvo Diesel Generator to Malaysia


This 250kva Volvo engine diesel generator is housed in a soundproof generator enclosure which muffles the sound and protects the generator from all weathers, fire protection, humidity & dusty. It can be installed outdoor or indoor and the noise level is 75 dB at 7 meters. The silent diesel generator is suitable for powering homes, hospitals, schools, and other industrial sites.


The genset is equipped with a 400A Schneider automatic transfer switch (ATS), which has the ability to switch the diesel generator on when there is a loss of power, and once the regular power supply comes back, it turns off. The bottom fuel tank has a capacity of 500L, which can meet the client’s specific needs.


New diesel generator operation guide


Nowadays, modern diesel generators have significantly corrected many problems of traditional diesel generators with electronic control direct injection, common rail, turbocharging and intercooling technology. When you buy a new diesel generator, keep in mind that you should follow the user manual to operate the unit. Below are some rules of running diesel generators:


1. In the initial operation of 40 hours of a new diesel generator, its speed should be limited to 80% of the rated speed.


2. Diesel generators for construction machinery should operate under partial loads for the first 40 hours.


3. Follow the recommendations and instructions to perform daily generator maintenance. Check the oil pressure gauge, temperature gauge, warning light and other instruments after using the new equipment to ensure their normal operation.


4 Add engine oil to the oil pan if it is without lubricating oil. If the cooling system is already filled with coolant, check the performance of the coolant. If it does not meet the requirements, you need to discharge it and then add the coolant that meets the standard.


5 When starting, separate the diesel generator from the drivetrain or put the transmission in neutral.


6. Turn the start button to start the diesel generator. In order to prevent damage to the starter and protect the batteries, the cold starting time should not exceed 30 seconds at each start, and the interval between two consecutive starts should be at least 2 minutes.


7. The reading of the oil pressure gauge should be displayed within 15 seconds of starting.


8. After a cold start of the diesel generator, increase the speed gradually to ensure that the bearing is fully lubricated and the oil pressure is maintained. Keep the generator idling for 3 to 5 minutes and then run it with loads.


If you are looking for a new diesel generator but not sure how to choose, feel free to contact us with any questions, concerns, or inquiries to learn more about the products & services we provide.


Comments

Popular posts from this blog

New Yuchai engine YC6K600-D30 power for diesel generator 50Hz

Technical Parameters of Boduan 500KW Weichai Generator Set 6M33D572E200

  The 6M33D633E200 diesel engine is a special-purpose diesel engine for land-based power generation in the M33 series. It is a new-structure power generation diesel engine with a centrally - located turbocharger developed by Weichai Power Co., Ltd. in 2016. Continuous Power (COP): The maximum power at which the diesel engine can run continuously under a constant load with no limit on the annual operating hours. It is the ISO standard power. Prime Power (PRP): The maximum power at which the diesel engine can run continuously under variable loads with no limit on the annual operating hours. It is an ISO standard power that allows a 10% overload. Standby Power (ESP): The maximum power in a certain variable - power series that the diesel engine can operate for up to 200 hours per year. It is an ISO standard power with limited fuel consumption.   Operating Conditions and Applications of Baudouin  500KW Weichai Generator Set  Diesel Engine Power Classification Operating Co...

How to know and solve faults of genset voltage transformer

 Today Starlight Power shares the common faults for voltage transformer of diesel generator set. Hope it is helpful to you. 1) The insulation between iron chips is damaged. Fault phenomenon: temperature rises during operation. The possible causes of the failure are: poor insulation between iron chips, bad use of environmental conditions or long-term operation under high temperature, which promote the insulation aging between iron chips. (2) Poor contact between grounding plate and iron core. Fault phenomenon: there is discharge sound between iron core and oil tank during operation. Cause of failure: the grounding plate is not inserted tightly, and the mounting screw is not tightened. (3) The iron core is loose. Fault phenomenon: abnormal vibration or noise during operation. The cause of failure: the iron core clamp is not clamped, and the iron chip is loose. (4) Turn to turn short circuit of winding. Fault phenomenon: during operation, the temperature rises, there is ...