Fault Codes on Indicator Light of Cummins Generator

 Do you know how to read fault codes Cummins generator indicator light? Starlight generator factory here tell you.

The control system of Cummins diesel generator (land use generator driving type) can display and record some operation faults, and these faults are expressed in the form of fault codes. These fault codes can make faults analysis easier. The fault codes are recorded in ECM. These fault codes can be read by using the fault indicator on the dashboard or the INSITETMTM service tool.

1.Displaying fault code on fault indicator

Most, but not all, electronic fault codes turn on the fault indicator when they work. When a fault code works, four kinds of fault indicator lights may turn on.

A.If “ warning” Indicator light is yellow, indicating we should remove faults as soon as possible;

B.If “stop” indicator light is red, indicating we need to shut down the diesel engine safely as soon as possible;

C.Diesel land use generators should be maintained in a state of shutdown until all faults are removed;

D.When maintain diesel generator, “Mait” maintenance indicator will flashes;

E.The diesel generator set is also equipped with a "water in fuel" (W.I.F) indicator. "there is water in fuel" (W.I.F) indicator indicates that water in oil-water separator of diesel generator needs to be discharged. As long as the indicator lights up, drainage should be carried out as soon as possible;

F.To check whether there are fault codes of diesel generator electronic system and maintenance indicator codes, the key switch should be transferred to the "OFF" position and the "diag" diagnostic switch should turn on;

G.Then turn the key switch to “ON” connection position, if the current fault code is not recorded, the indicator lamps will turn on, and the “warning” indicator lamp and "stop" indicator light will always turn on; if the current fault codes are recorded, the “warning” indicator lamp and "stop" indicator lamp will turn on in an instant. The “stop” indicator lamp will turn on instantaneously and then start recording the fault codes.

2.The fault code indicator lights flicker in the following order:

A.The yellow “warning” indicator lamp flashes.

B.1~2s suspension.

C.(2) 1-2s suspension.

D.The fault codes will flicker on the red “stop” indicator lamp.

E.There will be a 1-2 s pause between each number.

The yellow warning light flashes again when the number flickers through the red indicator. Failure numbers will flicker repeatedly in the same order. Each fault code will flicker twice and then go to the next fault code.

If want to skip the next fault code quickly, temporarily pull “idle/diag” adjustment switch to the (+) position. If want to get back to last fault codes, just temporarily pull “idle/diag” adjustment switch to the (-) position. If it only records one current fault code, whatever pull to (+) position or (-) position, the control system will keep displaying a same fault code.

If you can know the meaning of fault codes of the indicator light on Cummins generator, you will be able to remove faults quickly.